Extra Lathe Programming Videos

Watch this 7:57 video by Tom Stikkelman:  CNC LATHE PROGRAMMING LESSON 1 – LEARN TO WRITE A G72 CANNED CYCLE FOR FACING ON A CNC LATHE

Watch this 6:51 video by Tom Stikkleman: CNC LATHE PROGRAMMING – LESSON 2 – PT2 OF 2 – G71 CANNED CYCLE FOR ID ROUGHING.

Watch this 6:06 video by Tom Stikkleman: CNC LATHE PROGRAMMING LESSON 3 – G70 FINISHING CYCLE

Watch this 8:07 video by Tom Stikkleman: CNC LATHE PROGRAMMING LESSON 4 – BASIC CNC LATHE PROGRAM FORMAT

Watch this 6:59 video by Tom Stikkleman: CNC LATHE PROGRAMMING LESSON 6 – TOOL NOSE RADIUS COMPENSATION

Try this for practice:

Watch this 4:58 Exercise 1 by Tom Stikkleman: CNC LATHE PROGRAMMING EXERCISE 1

Watch this 15:34 review of Exercise 1 by Tom Stikkleman: CNC LATHE PROGRAM REVIEW OF EXERCISE 1

Look for other useful videos from Tom Skikkleman:  CNC Lathe Programming

License

Icon for the Creative Commons Attribution 4.0 International License

Support for CNC Copyright © by Lisa Hillyard is licensed under a Creative Commons Attribution 4.0 International License, except where otherwise noted.

Share This Book