Lead Out

Code Practice

After the program for cutting around the part (the profile), it is a best practice to move the cutting tool past the part. Move the position of the cutting tool to a safe position. It is the same measurement of using the cutter radius plus 0.100″. Moving the cutter past the part makes sure the cut is complete.  It also removes the sharp edges. 

The Lead Out and Cutter Compensation Cancel commands will be on the same line of code.

Questions

 

 

License

Icon for the Creative Commons Attribution 4.0 International License

Support for CNC Copyright © by Lisa Hillyard is licensed under a Creative Commons Attribution 4.0 International License, except where otherwise noted.

Share This Book